|
 Roll Splitter
| |
 |
|
| |
| Model 30 Roll Splitter prepares to remove shrink film from its
cardboard core. |
|
|
| |
|
|
| |
 |
|
| |
| Model 30
Roll Splitter with safety gate closed and ready for operation.
|
|
|
Stop using dangerous, labor-intensive manual razor-cutting and chopping to remove your paper, film, foil, nonwovens and other materials from the roll. Our roll splitters deliver hundreds of pounds of uniform cutting force per inch roll width, slicing through your material in less than one minute. You get, clean pre-cut material that prevents surging downstream and speeds the entire process. Since they don't cut through the core, there is no fiber contamination and the core can be reused. Plus, they are versatile, handling either a single roll or any mix of the same or varying diameter butt rolls.
Meets or exceeds OSHA safety standards with these safeguards:
- Electrically interlocked safety surround enclosure
- Full guarding around knife
- Electrical interlock on mandrel locking device
- Two-hand operating control
- Viewing window to safely oversee operations
- Knife Holder Safety Pin, for preventative maintenance
Our standard roll splitter accommodates 30-inch roll diameters. Our Rollmaster splitter accommodates 52-inch rolls, ideal for even the largest extruders.
Capacity (52" Rollmaster):
| Roll Splitter Model |
Maximum Roll Length |
Maximum Roll Diameter |
Footprint |
| Model 30 |
30" |
15" |
52"long x 42" wide |
| Model 52 |
52" |
40" |
93" long x 94" wide |
| Model 62 |
62" |
40" |
103" long x 62" wide |
| Model 72 |
72" |
40" |
116" long x 60" wide |
NOTE: PAC can custom design a roll splitter to fit your specifications.
See Roll Splitter remove plastic from a roll
Watch Video
|
|
 |
